Princess
85 #12

1 Engine replaced 2022 – Full warranty
Camera on aft
Electrolux internal vacuum system
Flir night vision camera
Sleipner Steering system
Watermaker Idromar
Survitec Zodiac XTREM
Opacmare crane on fly
Day head on main deck
Extra dryer (2021)
Extra washer (2021)

First owner, Lengers trade in.

Works done last years

Both engines overhauled for a total of 500K.
Air Conditioning compressors: Supply and Replacement of n°4 compressors
AirCon piping: ER SW and FW manifold and piping replacement, including expansion tank
Air Con: SW/FW pumps N°2 Pumps service
Bow Thruster ABT TRAC: Full service
Bow Thruster ABT TRAC: Supply and installtion of the missing cone on the PS side
Stern Thruster ABT TRAC: Full service
Megger Test:
– Generators
– Main engine starters & alternators
– Frequency converters
– AC main & secondary switchboards (excluding navigation instruments)
– Alternative electrical motors”
Batteries:  Replacement of
– Service Pack;
– MMEE starter pack;
– DDGG strter pack
Fire fighting: Full replacement
IDROMAR Water Maker MC3J  Annual Service + Pumps service
Filtering/Softener System – UW Light “Dismounting of UV LAMP and disassembling
– Manual Cleaning of the Quartz
– Supply and replacement of the UV Lamp
– Final test”
FW lines and tanks: chlorination treatment carried out
Antifouling: Application Done
Anodes: Supply and replacement
Rudders: clearances measured
P Brackets: Outer Seals renewal
PTOs: Full service including bench test and report
STBD Main Engine: Major Overhaul including short block replacement
STBD Main Engine
STBD Main Engine – Disembarkation (saloon): Floor cutting and restoration
STBD Main Engine – Disembarkation (ER): insulation removal, supply and installation of new one; pipes removal and reconnection
STBD Main Engine – Disembarkation (ER): electrical assistance for disconnection/reconnection of lights etc;
PORT Main Engine: Major Overhaul including short block replacement and all above
Pre- and alignment measurements: to be carried out prior MMEE removal and after re-installation, report included
Thru-Hull inlets/outlets: To be serviced/replaced (attention to MMEE, black water overboard three-way discharge valves )
ABT TRAC Fins: Full service as per manufacturer recommendation
Electric Pump Bosch type: Full service including: Tank draining
– Replacement of filters
– Pump overhaul
– Pistons overhaul
– Filling
– Pressure tests
Shower Drain: Full service of the Jabsco type discharge boxes
Windlass: Full service
ER bilges: Deposits and Liquids removal; degreasing; cleaning (evaluate repainting)
Fuel tanks: Cleaning of 2x daily tanks
– 1x deposit tank
– including fuel polishing;
– opening and closing of manholes;
– disposal
LSA/FFE: Annual service of Portable Fire Extinguishers, Liferafts, EPIRB
Portholes: Bolts need to be adjusted;
– All seals to be checked;
– VIP and PS Guest Bathroom are leaking
– Stainless steel to be polished
Windows: Caulking re-done
Superstructure Polishing
Hull Polishing
Tender out-board Yamaha: Annual Service
Shower Walls: Recaulking:
-Masking;
– Uncaulking and re-caulking
Shower Floor: Protection and masking;
– Uncaulking and re-caulking
Potable water system: to be serviced and tap (leaking) repaired
Crew Stairs: Reparation of the first step
Crew Bathroom: Refitting of the shower floor:
– Disassembly of the shower tray;
– Supply and installtion of an aluminium tray including a teak removable board
Crew Bathroom: Panel replacement in Crew Shower
CAT rpm indicators Replaced
Power Management System: Restore start-stop feature of the Auxiliary Generators from Bridge panel as designed
– Load meters to be checked (When G2 on line the busbar of G1 shows 168V instead than 220V)
Power Management System: Troubleshooting on control panel to restore BW pump, Genset start/stop and Voltage reading on shore power, Fire alarm panel
Fire Alarm Monitoring System Replacement of the faulty monitoring unit
Aft Docking Station Thrusters replaced
Emegency Escape FWD VIP Cabin: Creation of a plywood frame, similar to the wood originally used throughout the boat.
– Putting the frame around the opening where the scratch pads are now.
– Cutting the plywood without damaging the sky to create the hatch (57cm per side)
– Installing hinges, locking system (magnet or click)
– Creation of an anti-light system.
Emegency Escape FWD VIP Cabin: Supply
– BIG telescopic ladder for 5-step walkway
– Folded : 454 mm
– Unfolded : 1415 mm”